A
-
Alemi, M.
Recognizing Acceptance Level in Facial Expressions by Neural Network [37.3, Issue 2, 2021, Pages 13-20]
-
Alinia-ziazi, A.
Minimum weight design of truss structure via force method and Jaya algorithm” [37.3, Issue 1, 2021, Pages 27-36]
-
Amini Magham, M.R.
Sensitivity Analysis of the Dominant Design Parameters of Supersonic Separators
for Gas Compositions [37.3, Issue 1, 2021, Pages 111-123]
-
Arjmand, N.
Evaluation and management of workers’ musculoskeletal injury risks during handling/installation of the driver car seat in Iran-Khodro industrial group [37.3, Issue 2, 2021, Pages 29-35]
-
Asempour, A.
Investigation of Texture Intensity Effect on Deformation Behavior of Extruded Mg-0.8wt%Y Alloy under Tensile and Compressive Loading Using the Crystalline Plasticity Finite Element Method [37.3, Issue 1, 2021, Pages 59-69]
-
Asghari, M.
Study the effect of suction flow control on the aerodynamic performance of a wind turbine using 2D section numerical Results [37.3, Issue 1, 2021, Pages 79-89]
-
Ashouri-sanjani, M.
Evaluation and management of workers’ musculoskeletal injury risks during handling/installation of the driver car seat in Iran-Khodro industrial group [37.3, Issue 2, 2021, Pages 29-35]
-
Assari, M.R.
Simulation of a Double Slope Solar Still with Rotating External Reflector [37.3, Issue 2, 2021, Pages 21-28]
B
-
Barzegari, A.
Minimum weight design of truss structure via force method and Jaya algorithm” [37.3, Issue 1, 2021, Pages 27-36]
-
Bayareh, M.
Comprehensive study of particle separation in microfluidic devices [37.3, Issue 1, 2021, Pages 91-110]
F
-
Fallahi, F.
Multi-objective optimization of hydraulic engine mounts vibrational behavior by non-dominated sorting genetic algorithm [37.3, Issue 1, 2021, Pages 49-58]
-
Farhani, S.
Investigating the efficiency of piezoelectric wind energy harvesting in leaf-stalk structures [37.3, Issue 2, 2021, Pages 81-95]
G
-
Ghaffarzadeh, S.
Experimental Investigation of the Effect of Pilot Fuel Injection Pressure and Start of Injection on Combustion and Emission of RCCI Engine fueled with Diesel-CNG [37.3, Issue 1, 2021, Pages 37-48]
-
Ghasemi, B.
Comprehensive study of particle separation in microfluidic devices [37.3, Issue 1, 2021, Pages 91-110]
-
Ghorbanian, K.
Numerical investigation of transient temperature separation phenomenon in vortex tube [37.3, Issue 1, 2021, Pages 3-15]
-
Ghorbanian, K.
Sensitivity Analysis of the Dominant Design Parameters of Supersonic Separators
for Gas Compositions [37.3, Issue 1, 2021, Pages 111-123]
H
-
Hashemi, M. Y.
Study the effect of suction flow control on the aerodynamic performance of a wind turbine using 2D section numerical Results [37.3, Issue 1, 2021, Pages 79-89]
-
Hedayati-Azar, A.
A review of research approaches to contaminant transport in saturated deformable clay under coupled hydro-chemico-mechanical processes [37.3, Issue 2, 2021, Pages 97-115]
J
-
Jafarzadeh Kenari, S.
Numerical modeling and geometric optimization of single-phase supersonic ejector [37.3, Issue 1, 2021, Pages 71-78]
K
-
Karimi, S.
Simulation of a Double Slope Solar Still with Rotating External Reflector [37.3, Issue 2, 2021, Pages 21-28]
-
Karimian Aliabadi, S.
Study the effect of suction flow control on the aerodynamic performance of a wind turbine using 2D section numerical Results [37.3, Issue 1, 2021, Pages 79-89]
-
Kiani, M.
Simultaneous Orbit, Attitude and Albedo Parameter Estimation Using Satellite Surface Temperature Data [37.3, Issue 2, 2021, Pages 47-55]
L
-
Labibian, A.
Simultaneous Orbit, Attitude and Albedo Parameter Estimation Using Satellite Surface Temperature Data [37.3, Issue 2, 2021, Pages 47-55]
M
-
Maghsoudpour, A.
Minimum weight design of truss structure via force method and Jaya algorithm” [37.3, Issue 1, 2021, Pages 27-36]
-
Mahbadi, H.
Stress intensity factor for a small radial crack located on external edge of a rotating viscoelastic cylinder subjected to internal pressure and temperature distribution [37.3, Issue 1, 2021, Pages 17-26]
-
Meghdari, A.
Recognizing Acceptance Level in Facial Expressions by Neural Network [37.3, Issue 2, 2021, Pages 13-20]
-
Mirjalili, M.R.
Numerical investigation of transient temperature separation phenomenon in vortex tube [37.3, Issue 1, 2021, Pages 3-15]
-
Mirzakhani, A.
Investigation of Texture Intensity Effect on Deformation Behavior of Extruded Mg-0.8wt%Y Alloy under Tensile and Compressive Loading Using the Crystalline Plasticity Finite Element Method [37.3, Issue 1, 2021, Pages 59-69]
-
Moayyedi, M. K.
Reduced Order Model of Conduction Heat Transfer in a Solid Plate Based on Dynamic Mode Decomposition [37.3, Issue 2, 2021, Pages 3-12]
-
Mohajeri, S.H.
Exploring impacts of inlet condition on flow structure in a Compound open-channel using PIV [37.3, Issue 2, 2021, Pages 37-46]
N
-
Nabatian, N.
Numerical modeling and geometric optimization of single-phase supersonic ejector [37.3, Issue 1, 2021, Pages 71-78]
-
Nabatian, N.
Numerical investigation of the premixed V-flame stabilization and blowout [37.3, Issue 2, 2021, Pages 57-67]
-
Nabipour, M.
Exploring impacts of inlet condition on flow structure in a Compound open-channel using PIV [37.3, Issue 2, 2021, Pages 37-46]
-
Nasihati Gourabi, F.
Simultaneous Orbit, Attitude and Albedo Parameter Estimation Using Satellite Surface Temperature Data [37.3, Issue 2, 2021, Pages 47-55]
-
Nassiri Toosi, A.
Experimental Investigation of the Effect of Pilot Fuel Injection Pressure and Start of Injection on Combustion and Emission of RCCI Engine fueled with Diesel-CNG [37.3, Issue 1, 2021, Pages 37-48]
-
Nazemi Ashani, M.
Comprehensive study of particle separation in microfluidic devices [37.3, Issue 1, 2021, Pages 91-110]
-
Nikpour, R.
Stress intensity factor for a small radial crack located on external edge of a rotating viscoelastic cylinder subjected to internal pressure and temperature distribution [37.3, Issue 1, 2021, Pages 17-26]
P
-
Parvar, M.
Simulation of a Double Slope Solar Still with Rotating External Reflector [37.3, Issue 2, 2021, Pages 21-28]
-
Pourtakdoust, S.H.
Simultaneous Orbit, Attitude and Albedo Parameter Estimation Using Satellite Surface Temperature Data [37.3, Issue 2, 2021, Pages 47-55]
R
-
Rafiei, S.
Evaluation and management of workers’ musculoskeletal injury risks during handling/installation of the driver car seat in Iran-Khodro industrial group [37.3, Issue 2, 2021, Pages 29-35]
-
Reyhanian, M.
Experimental Investigation of the Effect of Pilot Fuel Injection Pressure and Start of Injection on Combustion and Emission of RCCI Engine fueled with Diesel-CNG [37.3, Issue 1, 2021, Pages 37-48]
-
Rezazadeh, Gh.
Multi-objective optimization of hydraulic engine mounts vibrational behavior by non-dominated sorting genetic algorithm [37.3, Issue 1, 2021, Pages 49-58]
S
-
Sabaghzadeghan, F.
Reduced Order Model of Conduction Heat Transfer in a Solid Plate Based on Dynamic Mode Decomposition [37.3, Issue 2, 2021, Pages 3-12]
-
Sadeghi, H.
A review of research approaches to contaminant transport in saturated deformable clay under coupled hydro-chemico-mechanical processes [37.3, Issue 2, 2021, Pages 97-115]
-
Sadeghian, N.
Simulation of a Double Slope Solar Still with Rotating External Reflector [37.3, Issue 2, 2021, Pages 21-28]
-
Sadeghi Dodaran, R.
Exploring impacts of inlet condition on flow structure in a Compound open-channel using PIV [37.3, Issue 2, 2021, Pages 37-46]
-
Salehi Neyshabouri, S. A.A.
Exploring impacts of inlet condition on flow structure in a Compound open-channel using PIV [37.3, Issue 2, 2021, Pages 37-46]
-
Shabani, R.
Multi-objective optimization of hydraulic engine mounts vibrational behavior by non-dominated sorting genetic algorithm [37.3, Issue 1, 2021, Pages 49-58]
-
Shahmiri, F.
Application of Axiomatic Design approach to reduce coupling and repetition in the UCAV conceptual design process [37.3, Issue 2, 2021, Pages 69-79]
-
Shirazi, M.
Numerical modeling and geometric optimization of single-phase supersonic ejector [37.3, Issue 1, 2021, Pages 71-78]
-
Shiriny, A.
Comprehensive study of particle separation in microfluidic devices [37.3, Issue 1, 2021, Pages 91-110]
-
Shooshtari, A.R.
Investigating the efficiency of piezoelectric wind energy harvesting in leaf-stalk structures [37.3, Issue 2, 2021, Pages 81-95]
T
-
Tamanaee, E.
Recognizing Acceptance Level in Facial Expressions by Neural Network [37.3, Issue 2, 2021, Pages 13-20]
-
Tariverdilo, S.
Multi-objective optimization of hydraulic engine mounts vibrational behavior by non-dominated sorting genetic algorithm [37.3, Issue 1, 2021, Pages 49-58]
Z
-
Zarrati, A.R.
Exploring impacts of inlet condition on flow structure in a Compound open-channel using PIV [37.3, Issue 2, 2021, Pages 37-46]
Your query does not match with any item